3rd Brake Light Pulsating Control Module 4 pulse alert then goes bright BBL-1A

Description

Third Brake Light Safety Control Module by
Mobilistics
™
LOW COST..EASY TO INSTALL.
Increase your safety !
New and factory tested...Super Small ...installs inside High Mounted Centered Third Brake Light Housing. Delivers a highly effective way to get the attention of the person behind you that you have applied the brakes. Right and Left Brake lights work normally. Not for use on Motorcycle or Standard Brake Lights.
Works on ANY type of standard incandescent or LED lighting. Operates 1 third brake lamp containing 1 to 3 bulbs or up to 55 LED's, (up to 5 amps). The BBL-1A simply connects to positive and negative wires powering you lamp. Hardware includes a quick disconnect system for quick removal and reconnect wiring.
• 4 pulses within 3 seconds, then goes bright then resets after brake is released.
• Installs in 5 minutes on most vehicles.
• Very Small fits in 3rd brake light housing (1-3/8"x7/8"x 1/2") can be removed from case and wrapped with electrical tape to fit even smaller area's if necessary.
• EZ installation instructions.
• Includes all necessary hardware.
MADE IN USA with domestic and imported parts
IMPORTANT. This system only works on the "Center Upper Mounted 3rd Brake Light" on cars, trucks, etc..This system
does not
work on a motorcycle brake/tail light
or any vehicle standard brake/tail lights.
Does not work on the models listed, or any of 2018-UP vehicles.
2009-UP Ford Focus
2014-UP Ford Escape
2004-UP Mercedes (most)
2009-UP Jaguar
2016-UP Dodge Truck
2010-UP Chevrolet HHR
2016-UP Hyundai
2018-UP Toyota
Model # BBL-1A