New RMT Aircraft Wing Leading Edge Bending Machine

Description

Revolution Machine Tools
New and Used Machine Tools Experts for 25 Years
We take pleasure in helping our customers succeed!
templette
TYPE
F-FAB 12-1
Number of rolls
Pcs.
3
Rolls Length
mm
3650
Bending capacity
mm
1.6
Top roll diameter
mm
25
Bottom roll diameter
mm
45
Length
mm
5350
Width
mm
850
Height
mm
1950
Weight approx.
Kg
~ 2850
Total installed power
Kw
1.8+1.8+1.8
Working height
mm
1000
Max. center distance of the bottom rolls
mm
75
Max. pass through
mm
50
Power supply
380V / 3 Phase / 60 Hz
Feeding rolls
3 roll drive
Rolls positioning
Digital readout
Rolls calibration
Manual
* All datas given according to 410 Mpa tensile strength
`
All Rolls driven by 2-Speed Motor
TOP ROLL LIFT MOTORS
Geared motor to screw located on each end.
Digital readout for each end of Top Roll
Each motor with Mechanical Brake
BOTTOM ROLLS:
Each with In/Out Adjustment and Indicators located on both end.
TIE ROD BED ADJUSTMENT to put slight bow in bed.
CONTROLS:
Roll Drive Motor Start/Stop Buttons.
Two Roll Speed in Forward/ one Roll Speed in Reverse.
TOP ROLL Up/Down buttons to adjust BOTH END elevation screws at same time.
TOP ROLL Up/Down buttons to independently adjust EACH END elevation screws.
Safety Stop located on the control panel and safety stop wire located around the machine.
All Rolls driven by 2-Speed Motor
Revolution Machine Tools
Our Senior Service & Application Specialists are the best in the world, standing by to help install, perform on-sight training, maintenance and repair of your equipment.
We can carefully load all machines and arrange transportation if necessary.
templette